Writing CDs

In response to this demand, electronics manufacturers introduced an alternative sort of CD that could be encoded in a few easy steps. CD-recordable discs, or CD-Rs, don't have any bumps or flat areas at all. Instead, they have a smooth reflective metal layer, which rests on top of a layer of photosensitive dye.

When the disc is blank, the dye is translucent: Light can shine through and reflect off the metal surface. But when you heat the dye layer with concentrated light of a particular frequency and intensity, the dye turns opaque: It darkens to the point that light can't pass through.

A CD-R doesn't have the same bumps and lands as a conventional CD. Instead, the disc has a dye layer underneath a smooth, reflective surface. On a blank CD-R disc, the dye layer is completely translucent, so all light reflects. The write laser darkens the spots where the bumps would be in a conventional CD, forming non-reflecting areas.

By selectively darkening particular points along the CD track, and leaving other areas of dye translucent, you can create a digital pattern that a standard CD player can read. The light from the player's laser beam will only bounce back to the sensor when the dye is left translucent, in the same way that it will only bounce back from the flat areas of a conventional CD. So, even though the CD-R disc doesn't have any bumps pressed into it at all, it behaves just like a standard disc.

A CD burner's job, of course, is to "burn" the digital pattern onto a blank CD. In the next section, we'll look inside a burner to see how it accomplishes this task.